John Deere Products & Services D100 User Manual download pdf (Page 35)

GXAL42008—UN—04MAR13

Twin cylinder engine shown

4. Remove dipstick (A). Wipe with clean cloth.

5. Install and tighten dipstick.

6. Remove dipstick.

7. Check oil level on dipstick. Oil must be between ADD and FULL

marks.

8. If oil level is low, add oil to bring oil level no higher than FULL mark on

dipstick. Do not overll.

9. Install and tighten dipstick. Lower hood.

Changing Engine Oil and Filter

IMPORTANT: Change the oil more often if the vehicle is used in

extreme conditions:

• EExxttrreemmeellyy dduussttyy ccoonnddiittiioonnss..

• FFrreeqquueenntt ssllooww oorr llooww--ssppeeeedd ooppeerraattiioonn..

• FFrreeqquueenntt sshhoorrtt ttrriippss..

1. Run engine to warm oil.

2. Park machine safely. (See Parking Safely in the SAFETY section.)

3. Lift hood.

4. Remove closeout panels.

GXAL42009—UN—04MAR13

Twin cylinder engine shown

5. Put drain pan under drain valve (A).

6. Rotate and remove drain cap (B) and drain oil into oil drain pan. Allow

oil to drain completely.

7. Remove dipstick (C).

GXAL42010—UN—04MAR13

Twin cylinder engine shown

8. Replace oil lter (D), if equipped.

a. Wipe dirt from around oil lter.

b. Place a drain pan or funnel under lter tray.

c. Remove old lter and lter gasket and dispose of properly. Wipe

up any spilled oil.

d. Put a light coat of fresh, clean oil on the new lter gasket.

e. Install replacement oil lter by turning oil lter to the right

(clockwise) until the rubber gasket contacts lter base. Tighten

lter an additional one-half turn.

9. Install drain cap.

IMPORTANT: Do not overll. Overlling can cause smoking, hard

starting, fouling of spark plug, and oil saturation of air lter.

10. Add oil no higher than FULL mark on dipstick. Use approximately the

amount of oil listed in the Specications section. Do not overll.

11. Install dipstick.

Service Engine

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 63 64

Comments to this Manuals

No comments

John Deere Products & Services D100 User Manual Page 35

Comments to this Manuals