John Deere Products & Services D100 User Manual download pdf (Page 41)

IMPORTANT: To prevent clutch damage, make sure front draft rod is

installed correctly. Secure rod with washer and spring

locking pin on the left side of mower deck bracket.

GXAL42030—UN—04MAR13

107 cm (42 in.) mower deck shown

7. Install front draft rod (D) into mower deck bracket (E):

• For D105 models use the hole marked AUTO (shown).

• For all other models use the hole marked HYDRO (F).

8. Secure front draft rod with washer and spring locking pin (G).

CAUTION: Component is spring-assisted and under tension.

Injury can occur if spring-assisted component is released

suddenly.

GXAL42031—UN—04MAR13

122 cm (48 in.) mower deck used for photo purposes.

9. Put mower drive belt on engine drive sheave (H).

• On 122 cm (48 in.) and 137 cm (54 in.) mower decks: Put a 15 mm

closed wrench or a socket on the idler sheave nut (I) and rotate

clockwise, moving idler sheave and tensioning arm toward front of

tractor. Hold while installing belt on drive sheave.

GXAL42032—UN—04MAR13

• On 107 cm (42 in.) mower deck: Make sure belt is routed through

both belt guides (J).

10. Remove wood blocks from both sides of mower deck.

11. On machines with 107 cm (42 in.) mower deck: Attach mower

engagement drive cable.

GXAL42033—UN—04MAR13

107 cm (42 in.) mower deck only

a. Route cable under mower belt and brake rod and attach cable

spring (K) to idler sheave bracket (L).

b. Pull out on cable (M), align black end of cable with slot in bracket

(N) and release cable into slot. Secure with spring locking pin (O).

12. Level mower deck.

Replacing Mower Drive Belt (107 cm (42 in.)

Mower Deck)

1. Park machine safely. (See Parking Safely in the SAFETY section.)

2. Remove mower deck.

Service Mower

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 63 64

No comments

John Deere Products & Services D100 User Manual Page 41