John Deere Products & Services D100 User Manual download pdf (Page 39)

GXAL42023—UN—04MAR13

6. Slide hose clamps (A) away from fuel lter (B) using a pliers.

7. Disconnect hoses from lter, and raise fuel lines vertically to avoid

fuel drainage.

IMPORTANT: Incorrect installation of fuel lter may cause engine

damage. Install the lter with the arrow pointing in the

direction of fuel ow (towards the engine) for proper

operation.

8. Connect hoses to new lter making sure the lter arrow is pointed in

the direction of the fuel ow.

9. Install clamps and check for leaks.

10. Lower hood.

Service Transmission

Checking Transmission

The transmission is a sealed component. No maintenance is required on

this transmission. If you suspect any transmission problems, please

contact your authorized dealer.

Service Mower

Removing or Installing Mower Drive Belt at

Engine Drive Sheave 122 cm (48 in.) and 137

cm (54 in.) Mower Deck)

1. Park machine safely. (See Parking Safely in SAFETY section.)

2. Put lift lever in lowest position.

CAUTION: Component is spring-assisted and under tension.

Injury can occur if spring-assisted component is released

suddenly.

GXAL42024—UN—04MAR13

3. Put a 15 mm closed wrench or a socket on the idler sheave nut (A)

and rotate clockwise to move idler sheave toward front of tractor and

hold to release belt tension.

4. Remove belt (B) from drive sheave (C), and release tension on

sheave nut (A).

5. To install the belt on the drive sheave, rotate idler sheave nut

clockwise to move idler sheave toward front of tractor, and install belt

on drive sheave.

6. Release idler sheave nut to tighten belt.

Removing Mower Deck

1. Park machine safely. (See Parking Safely in SAFETY section.)

2. Put wood blocks under each side of mower deck.

3. Put attachment lift lever in lowest position, bringing mower deck

down onto blocks.

GXAL42025—UN—04MAR13

107 cm (42 in.) mower deck only

4. On machines with 107 cm (42 in.), disconnect mower engagement

drive cable (A) on left side of mower deck.

a. Remove spring locking pin (B), pull and hold mower engagement

drive cable out, lift up and remove from bracket (C).

b. Remove cable spring (D) from idler sheave bracket (E).

Service Transmission

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 63 64

Comments to this Manuals

No comments

John Deere Products & Services D100 User Manual Page 39

Comments to this Manuals