John Deere Products & Services D100 User Manual download pdf (Page 25)

The front blade tip must be specied distance lower than rear

blade tip.

Specication

Mower Deck Blade Outside Tips to Ground (Difference)

— Distance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3–6 mm (1/8 -1/4 in.)

GXAL41987—UN—04MAR13

107 cm (42 in.) mower deck shown

c. Adjust mower deck level, if necessary, by turning the nut (G)

counterclockwise to lower the front of deck or clockwise to raise

front of deck.

Adjusting Mower Deck Wheels

IMPORTANT: The mower deck can be damaged if mower wheels are

adjusted wrong:

• WWhheeeellss mmuusstt nnoott rriiddee oonn ggrroouunndd ssuuppppoorrttiinngg mmoowweerr wweeiigghhtt..

• CChheecckk wwhheeeell aaddjjuussttmmeenntt eeaacchh ttiimmee ccuuttttiinngg hheeiigghhtt iiss

cchhaannggeedd..

1. Park machine safely. (See Parking Safely in the SAFETY section.)

2. Inate tires to the correct pressure.

3. Lower mower deck to the desired mowing position.

NOTE: Bottom of wheels should be approximately 3-13 mm (1/8-1/2 in.)

from the ground.

GXAL41988—UN—04MAR13

4. Check each mower wheel position. Remove nut (A) and bolt (B), and

move mower wheel to proper hole.

GXAL41989—UN—04MAR13

A — 38 mm (1.5-In.)

B — 51 mm (2-In.)

C — 64 mm (2.5-In.)

D — 76 mm (3-In.) and above

5. Install bolts and nuts to lock wheels in position. Tighten nuts to

specications.

Specication

Mower Deck Wheel Nut — Torque . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 lb-ft (34 N·m)

Testing Safety Systems

MXAL42804—UN—09APR13

CAUTION: Engine exhaust fumes contain carbon monoxide

and can cause serious illness or death.

Do not run an engine in an enclosed area, such as a garage,

even with doors or windows opened.

Move the machine to an outside area before running the

engine.

The safety systems installed on your machine should be checked before

each machine use. Be sure you have read the machine operator manual

and are completely familiar with the operation of the machine before

performing these safety system checks.

Use the following checkout procedures to check for normal operation of

machine.

If there is a malfunction during one of these procedures, do not operate

machine. See your authorized dealer for service.

Perform these tests in a clear open area. Keep bystanders away.

Testing Park Brake Switch

1. Park machine safely. (See Parking Safely in the SAFETY section.)

2. Sit on seat.

3. Unlock the park brake.

Operating

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Comments to this Manuals

No comments

John Deere Products & Services D100 User Manual Page 25

Comments to this Manuals