John Deere Products & Services Cab A-11170 User Manual download pdf (Page 6)

05-10324

June 2003

John Deere 4100, 4110 and 4115

Mounting Instructions

G. The lower radiator hose will need to be cut for

installation of the lower radiator hose “T”

fitting #7-11308. See Figure 5G.

H. Install 5/8” hose to NPT fitting #3-12119 into

the lower radiator hose “T” fitting. See Figure

5G.

I. Measure and cut the 5/8” heater hose from

the right side (Return Line) of the cab with the

90-degree elbow #3-10282 to the lower

radiator hose “T” nipple fitting. See Figure

5G.

J. Tighten all hose connections with hose

clamps.

K. Re-connect Battery Power.

L. Refill radiator. Start engine and run at fast

idle to purge air from coolant system. Make

sure the Heat-Pull Lever is pulled out (Turned

On).

M. Check for leaks.

N. Check coolant level after heater core and

hoses are filled.

6. ADDITIONAL INSTRUCTIONS (4110 models, ONLY!)

A. Since the 4110 hood slightly differs from the 4100 and 4115, the fuel cap lid needs to be

modified. Remove ¾” from the end of the fuel cap lid as shown in Figure 6A.

B. The 4110 hood also sets back further towards the cab and therefore the hood will not open as

far as the other models. Install the shorter hood rod #7-15714 to prevent the hood from

contacting the cab. See Figure 6B.

7. VERTICAL EXHAUST KIT

A. For applications that require a high exhaust

system, over the head of the operator, a

vertical exhaust kit is available through you

local John Deere dealer.

Figure 5G

Figure 6B

(

4110 Models ONLY

)

Figure 6A

(

4110 Models ONLY

)

Note 6B

Note 6A

Note 5I

Note 5G

Note 5H

Page 6

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comments to this Manuals

No comments

John Deere Products & Services Cab A-11170 User Manual Page 6

Comments to this Manuals

Related products and manuals for Unknown John Deere Products & Services Cab A-11170